E-Z LOK™ Threaded Insert - Extra Heavy Wall - 303 Stainless Steel - 1/4-20 x 1/2-13
E-Z LOK™ Threaded Insert for Metal - Extra Heavy Wall - 303 Stainless Steel - 1/4-20 x 1/2-13
E-Z LOK™ (Solid Wall) threaded inserts with Extra Heavy Wall are ideal for reducing the size of tapped holes, typically after previous drilling/re-tapping operations. Like all E-Z LOK™ (Solid Wall) threaded inserts, the Extra Heavy Wall design is installed using standard drills and taps. Installation is performed with a screwdriver, bolt/jam nut, or optional E-Z LOK™ drive tool.
E-Z LOK™ (Solid Wall) Extra Heavy Wall inserts are self-locking. Immediately upon installation, pre-applied LOCTITE™ on the external threads begins to set and the newly installed insert is fastener ready in minutes. At full cure (72 hours), the Loctite™ seals against liquids and gases to pressures of 6,000 psi.
- Strong: screw machined out of solid steel for greater strength
- Easy to Install: simply drill, tap, and thread in like an ordinary fastener
- Standard OD Threads: permit the use of standard drills and taps
- Self-locking – preapplied LOCTITE™ adhesive activates on installation
- Vibration Resistant: adhesive secures the insert in place so it won’t back out
- Seals against Liquids/Gases: to pressures of 6,000 psi.
Applications:Soft metals: aluminum, cast iron, magnesium, etc.
Installation:Unlike coil inserts, which require a special tap and installation tool, E-Z LOK™ (Solid Wall) threaded inserts for metal are installed using standard tools, and installation is as easy as 1-2-3. Simply drill the appropriately sized hole with a standard drill Tap the hole with a standard tap Turn in the E-Z LOK™ (Solid Wall) insert like an ordinary fastener with a screwdriver, bolt and jam nut, or an E-Z LOK™ drive tool. E-Z LOK™ (Solid Wall) threaded inserts are self-locking and open immediately upon installation. The pre-applied LOCTITE™ on the external threads sets immediately allowing for the newly installed insert to be fastener ready. E-Z LOK solid wall threaded inserts are typically installed with the slots up. The slots accommodate a screwdriver or E-Z LOK drive tool. When using a bolt and jam nuts for installation, the slotted end of the insert can be either up or down.
|E-Z Lok P/N:||3353-4|
|For Use in:||Metal|
|Specific Material Use:||N/A|
|Sub-Category:||Extra Heavy Wall|
|Material:||Steel - Stainless|
|System of Measurement:||Inch|
|Minimum Full Thread Depth:||0.563|
|Installation Tool P/N:||500-3|