Drill out the hole with the specified drill. Confirm that the thread and pitch of the bolt match the tap. Tap the hole with the specified tap. Set the stop on the installation tool so the tang is centered in the slot.
Drill out the hole with the specified drill. Confirm that the thread and pitch of the bolt match the tap. Tap the hole with the specified tap. Set the stop on the installation tool so the tang is centered in the slot.
Wind the insert into the hole with a slight downward pressure until 1/4 to 1/2 turn below the surface. Remove the tang by placing the tang break tool on top of the tang and striking firmly with a hammer. Job Finished
Wind the insert into the hole with a slight downward pressure until 1/4 to 1/2 turn below the surface. Remove the tang by placing the tang break tool on top of the tang and striking firmly with a hammer. If a tang break tool is not available, the installation tool may be used.